Determination of yaw motion estimation for noise and error value based upon creep coefficient

Authors

  • Zulfiqar Ali Soomro Directorate of post graduate, Mehran University of Engg;&Tech; Jamshoro (Pakistan)

DOI:

https://doi.org/10.24949/njes.v7i1.137

Abstract

Abstract. Yaw/spin motion is one of the crucial parameter for three degrees of motion for railway vehicle wheelset for analyzing proper concerned dynamics and modeling. Perturbation is the cardinal problem during running of railway wheelset over track, which comprises many factors particularly improper adhesion and creep analysis causing disturbance on its smooth performance. Thus impropriate ratio of adhesion based upon contamination owing to creep creates slippage of rail wheels from track. This slip is procured by unbalanced lateral motion associated with yaw motion based upon variety in creep coefficient. In this paper, the produced noise by running high speed of railway wheelset is estimated by using kalman filter (KF) and error percentage is also determined.

References

References

J. B. Ayasse, and H. Chollet, Determination of wheel-rail contact patch in semi-Hertzian Conditions, Vehicle System Dynamics, Vol. 2. Oxford: Number 2, March 2005,pp. 161 – 172.

X Quost, M. S, A. Eddhahak, J.B. Ayasse, H. Chollet, and P.E. Gautier, Assessment of the semi-Hertzian method for the determination of the wheel-rail contact patch, Vehicle System Dynamics, vol. 44, No. 10, October 2006, pp. 789-814.

J.J. Kalker, Rolling contact Phenomena: Linear Elasticity, CISM International Centre for Mechanical Series, No. 41, Vol. 6, 2000, 394 pages.

J. Pombo, J. Ambrosio, M. Silva, A new wheel-rail contact model for railway dynamics, Vehicle System dynamics, Vol. 45, No. 2, February 2007, pp. 165 – 189.

R. Burden, and J. D, Faires, Numerical Analysis,Thompson Brooks Cole, 8th Edition, 2005, 837 pages.

. Anant, m. and a. Mehdi, Nonlinear investigation of the effect of primary suspension on the hunting stability of a rail wheelset, ASME Rail Transportation Division, vol.27, 53-61, 2004.

. Sadkov m. Ya., Passive stabilization conditions for a rectilinearly moving wheelset, International Applied Mechanics, Vol. 39, No. 8, pp 983-986, 2003.

. Mei, T.X. and Goodall, R. Wheelset Control Strategies for a Two-Axle Railway Vehicle. Proc. 16th IAVSD Symposium. Pretoria, South Africa, 1999. Vehicle System Dynamics 33 (Suppl.) (2000), pp. 653–664.

. Sireteanu, t., sebeşan, i., baldovin, d., The influence of damping characteristic on the stabilization control of hunting motion of a railway vehicle wheelset, Proc. of the Romanian Academy, Series A: Mathematics, Physics, Technical Sciences, Information Science, 11, 4, pp. 355-362, 2010.

T.X. Mei, A Study of Fault Tolerance For Active Wheelset Control, in 22 nd IAVSD, Manchester,UK, 2011.

Downloads

Published

2015-07-10

Issue

Section

Engineering Sciences